26"
Wet Abrasive Oscillating Cut-Off Machines complete with 30 or 40 H.P. TEFC motor,
magnetic starter with 110 volt at the push buttons, oscillation, air operated
"V" shaped chain hold-down vise, coolant tray, settling tank and pump.
Exclusive vibra-action oscillation moves the wheel back and forth while cut is
being made. This reduces the area of contact between the wheel and material, resulting
in improved quality of cut, less heat build up, less burr and increased wheel
life. Typical wet cutting speeds are 30 seconds per square inch of material based
on application.
Specifications
Capacity:
5" solids, most 7" shapes
Wheel Capacity: 26" diameter
Wet Non-Reinforced
and Reinforced Wheels
Motor: 30 or 40 H.P. Special Hi-Torque
Totally
Enclosed Fan Cooled
3 Phase Starter: Magnetic with thermal overload;
110 volt at the push buttons
Spindle Bearings: Heavy-duty sealed ball
bearings. Lubricated for life Arbor Shaft: 1" arbor
Drive: Positive
timing belt
Oscillator: 1/3 H.P. gear motor
Safety Guards: Cut-off
wheel and guards exceed safety code requirements Stop: Adjustable down
stop limits depth of chop stroke
Vise: Air operated "V" shaped
chain holddown vise. Hold various shaped materials
Hydraulic Power Head:
(PH models only) with hydraulic feed control valve for smooth accurate cutting
Wheel
Wear Compensator: (WWC & HP models only) senses end of cut, returns wheel
to up position
Oscillation: (OSC models only) For improved cutting,
reduced burr and longer wheel life
Oscillator: 1/3 H.P. gear motor
Shipping
Weight: (machines): 1900-2400 lbs.
