20"-22"
OSCILLATING Wet Abrasive Cut-Off/Met Lab Machines complete with 20 H.P. TEFC motor,
magnetic starter with 110 volt at the push buttons, air operated "V"
shaped chain hold-down vise, OSCILLATION, coolant tray, settling tank and pump.
Typical wet cutting speeds are 30 seconds per square inch of material based on
application. The cutting wheels on these Everett models are cooled by rotating
through a water box with hinged adjustable sides. The water ejector and the wheel
itself combine to throw the coolant into the cut and over the material to assure
total cooling. The flow and discharge are easily regulated with the control valve
and by adjusting the sides of the water box.
Specifications
Capacity:
3" solids, most 7" shapes
Wheel Capacity: 20" or 22" diameter
Wet
Non-Reinforced and Reinforced Wheels
Motor: 20 H.P. Special Hi-Torque
Totally
Enclosed Fan Cooled
3 Phase Starter: Magnetic with thermal overload;
110 volt at the push buttons
Spindle Bearings: Heavy-duty sealed ball
bearings. Lubricated for life
Arbor Shaft: 1" arbor
Drive: Positive
timing belt
Oscillator: 1/3 H.P. gear motor
Safety Guards: Cut-off
wheel and guards exceed safety code requirements
Stop: Adjustable down
stop limits depth of chop stroke
Vise: Air operated "V" shaped
chain holddown vise. Holds various shaped materials
Hydraulic Power Head:
(PH models only) with hydraulic feed control valve for smooth accurate cutting
Wheel
Wear Compensator: (WWC & PH models only) senses end of cut, returns wheel
to up position
Shipping Weight (machine): 1100-1800 lbs.
