Industrial Saw Machinery

20"-22" Wet Abrasive Cut-Off Machines complete with 20 H.P. TEFC motor, magnetic starter with 110 volt at the push buttons, air operated "V' shaped chain hold-down vise, coolant tray, settling tank and pump. Typical wet cutting speeds are 30 seconds per square inch of material based on application. The cutting wheels on these Everett models are cooled by rotating through a water box with hinged adjustable sides. The water ejector and the wheel itself combine to throw the coolant into the cut and over the material to assure total cooling. The flow and discharge are easily regulated with the control valve and by adjusting the sides of the water box.

Specifications
Capacity: 3" solids, most 7" shapes
Wheel Capacity: 20" or 22" diameter
Wet Non-Reinforced and Reinforced Wheels
Motor: 20 H.P. Special Hi-Torque
Totally Enclosed Fan Cooled
3 Phase Starter: Magnetic with thermal overload; 110 volt at the push buttons
Spindle Bearings: Heavy-duty sealed ball bearings. Lubricated for life
Arbor Shaft: 1" arbor
Drive: Positive timing belt
Safety Guards: Cut-off wheel and guards exceed safety code requirements
Stop: Adjustable down stop limits depth of chop stroke
Vise: Air operated "V" shaped chain holddown vise. Holds various shaped materials
Hydraulic Power Head: (PH models only) with hydraulic feed control valve for smooth accurate cutting
Wheel Wear Compensator: (WWC & PH models only) senses end of cut, returns wheel to up position
Oscillation: (OSC models only) For improved cutting, reduced burr and longer wheel life
Oscillator: 1/3 H.P. gear motor
Shipping Weight (machines): 1100-1800 lbs.