26"
Dry Abrasive Oscillating Cut-Off Machines complete with 30 or 40 H.P. TEFC motor,
magnetic starter with 110 volt at the push buttons, cabinet base and vise. Exclusive
vibra-action oscillation moves the wheel back and forth while cut is being made.
This reduces the area of contact between the wheel and material, resulting in
improved quality of cut, less heat build up, less burr and increased wheel life.
Fast, low cost cutting of hardened tool steel, bars, rounds, shapes, pipe, angle
iron, tubing, flat stock & rod.
Specifications
Capacity:
6" solids, most 7" shapes
Wheel Capacity: 26" diameter
Dry Reinforced
Wheels Motor: 30 or 40 H.P. Special Hi-Torque
Totally Enclosed Fan Cooled
3
Phase Starter: Magnetic with thermal overload; 110 volt at the pushbuttons
Spindle
Bearings: Heavy-duty sealed ball bearings. Lubricated for life
Arbor
Shaft: 1" arbor
Drive: Positive timing belt
Oscillator:
1/3 H.P. gear motor
Safety Guards: Cut-off wheel and guards exceed safety
code requirements
Stop: Adjustable down stop limits depth of chop stroke
Vise:
Sturdy work fence, screw clamp. "V" block air vise optional
Hydraulic
Power Head: (PH models only) with hydraulic feed control valve for smooth
accurate cutting
Wheel Wear Compensator: (WWC & PH models only) senses
end of cut, returns wheel to up position
Shipping Weight (machines):
1800-2100 lbs.
Cutting
Speeds (average)
Size | Material | Time |
6" | Solid | 115
sec. |
8"
x 8" | Angle | 20
sec. |
12" | Channel | 40
sec. |
