Specifications and Features

 NOTE:  Metric specifications represent nearest SI Unit converted from the basic U.S. Customary Unit.

Capacity:  Blade at 90°:  18” (457 mm) Horizontal, 20” (508 mm) Vertical;

Capacity:  Blade at 45°:  18” (457 mm) Horizontal, 14.5” (368 mm) Vertical;

Capacity:  Blade at 60°:  18” (457 mm) Horizontal, 10.5” (267 mm) Vertical;

Capacity:  Column in 3° forward cant position:  17.5” (445 mm) Horizontal, 20 (508 mm) Vertical;

Speed Range:  50 – 450 fpm (15 – 137 m/min) infinitely variable with inverter drive.

Front Mounted Speed Control:  Allows blade speed to be adjusted from operator's control station.

Feed Range:  0 – 250 lbs. (64 kgf) infinitely variable with control on operator's panel and

Automatic Column Return.  Column feed is mechanical with Marvel clutch power feed.

T-Slotted Work Table:  Work area 24.25” x 33” (616 mm x 838 mm); Table height 34.5” (876 mm);Two machined T-slots.

Wheel Diameter: 19” (482 mm), cast iron wheels.

Blade Break/Stall Detection: Standard equipment, shuts off machine in the event of blade breaking or stalling.

Miter Cutting:  Column and blade tilt up to 60° right and left of vertical; work always stationary.  Manual tilt standard with Sure-Lock and Built-in protractor.  Electric Power tilt optional.

Saw Column: Marvel patent pending Quick Change Column is standard on all machines.  Allows column to be set either upright or at a 3° forward cant3° forward cant.  Column travels on recirculating linear ball bearing rails.

Quick-Action Vise:  Maximum opening 20” (508 mm).  Jaws can be shifted to either right or left side of blade. Jaws are 6” (152 mm) high, 12” (305 mm) wide.

Automatic Stops:  Adjustable stops can be pre-set to stop advance and return of blade, and also to stop motor at any location within the 18” (457 mm) travel of the blade.

Coolant System: Built-in available with either flood, or ECO DROP system. Controlled by on-off selector switch at operator's station. Tank capacity 21 gallons (79 liters).

Flushing Hose: Washes chips from hard to get at places reducing clean-up time.

Power Chip Brush: Together with blade wipers and flood coolant deep blade teeth free of chips.

Carbide Guide System: Solid carbide post design equipped with Patent Pending Marvel Easy Load Guide Blocks.  Upper and lower guides have preloaded carbide faced back-up blocks to support back edge of blade.

Blade: 15' 4" (4674 mm) long x 1.25" (32 mm) wide, .042" (1.07 mm) thick.  One Welded-Edge Band Blade is furnished with each machine.

Motors:  Main; 5 H.P. (3.75 kW), 1800 RPM, totally enclosed fan cooled.  Coolant Pump; 1/4 H.P. (.2 kW) 3600 RPM totally enclosed motor-built-in integrally 240/480 or 575 volt, 3 phase, 60 Hz.

Controls:  IEC fused disconnect switch and magnetic motor starters, with overload and low-voltage protection.  Transformer provides low voltage control (120 volts) to all push buttons at operator's control panel and machine lighting circuits.  PLC control and components mounted in moisture proof NEMA 12 compartment.  Electrical Panel is UL labeled.

38